By joining you will help ensure that we can continue to provide this service
JOIN HERE!
bar backs
- schrader7032
- Posts: 9065
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 3 times
- Been thanked: 36 times
bar backs
I have bar backs (don't know the dimensions...didn't realize they came in different sizes) on my '78 R100/7...the bike also has a Luftmeister fairing and high (US) bars. I have no problems with the bar backs. I can't remember if I had to change the cables out...I don't remember doing that. I did initially reroute the cables to ensure no sharp turns especially around the upper triple tree.
However, after a number of years, I realized that the throttle cables were making too sharp of a bend where they went into the adjusters at the top of the carbs. The metal spiral inside the cable was beginning to show. I bought new cables for a '86 R80RT. They were the longest I could find that would work with the dual-cable system. They work just fine and there is no sharp bend into the carbs. The throttle cables were 1158mm long, part number 32 73 1 454 584.
So, the bar backs should be no problem, but you might need to change some cables out.
Kurt in S.A.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
bar backs
Just bought a 78 r100s and she's extemely clean, 28k, all original. I have a chance to buy some 2.4 inch bar backs and was wondering if these will work on this bike. Are there going to be clearance problems or other issues?
Thx,
Chris