By joining you will help ensure that we can continue to provide this service
JOIN HERE!
R 12 front stand
- Darryl.Richman
- Posts: 2138
- Joined: Fri Oct 27, 2006 3:00 am
- Has thanked: 1 time
- Been thanked: 9 times
R 12 front stand
I'll try to report back when I get the R12 together, hopefully later this summer. (But then, I thought I was going to have it together last fall...)
- Bruce Frey
- Posts: 536
- Joined: Fri Oct 27, 2006 3:00 am
R 12 front stand
There is a picture somewhere on the web...perhaps Dreher's site.
It is a spring steel clip. The material is 1.5mm and it tapers in width from about 25mm to about 15mm just where it makes the radius at the bottom
It has a curved section that engages and holds the front stand in a horizontal position.
I replied to your post on the Kradrider site and attached some pix in my reply. A picture is worth much more than a thousand of my words.
Best regards,
Bruce
R 12 front stand
I have two clips that I thought were correct but they are not long enough. If I put them back to back and then bolt an extention of say 20mm onto one end they work ok. It would be nice to get it right ... Regards Peter