Installing a new windshield and have a few questions.
1. I assume the round gasket material at the bottom of the windshield lays in the groove between the bottom edge of black dash and the fairing, is that correct?
2. Is there supposed to be a washer between the fastening rivet(under the head) and the windshield?
(as shown in max bmw fiche file)
3. How difficult is it to use the rivets without the “special tool”?
4. Opinions on pitching the plastic rivets and using the bolts and nuts instead, as promoted by max bmw’s fiche file?
Appreciate any guidance,
Patrick
If you like our site, please consider joining our club!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!
Windshield Install
-
"James Wiseman"
Re: [R90SWORLDNET] Windshield Install
I have been using stainless truss socket head bolts for years. I put an o-ring or a small rubber washer under the head to cushion the windshield and a nylon lock nut on the inside of the fairing.
Good luck.
James Wiseman
ProServUS Investigation
PO Box 802
Burlington, IA 52601
319-750-4199
The truth will set you free.
NOTICE: This email and any attachments are covered by the Electronic Communication Privacy Act. The information may be confidential. If you are not the intended recipient, you are hereby notified that any retention, dissemination, distribution or copying of this communication is strictly prohibited. Please reply to the sender that you have received this message in error, then delete it. Thank you for your cooperation.
Good luck.
James Wiseman
ProServUS Investigation
PO Box 802
Burlington, IA 52601
319-750-4199
The truth will set you free.
NOTICE: This email and any attachments are covered by the Electronic Communication Privacy Act. The information may be confidential. If you are not the intended recipient, you are hereby notified that any retention, dissemination, distribution or copying of this communication is strictly prohibited. Please reply to the sender that you have received this message in error, then delete it. Thank you for your cooperation.