By joining you will help ensure that we can continue to provide this service
JOIN HERE!
Rear bearing puller r60/2
Rear bearing puller r60/2
'63 r60/2
Scituate, MA
- schrader7032
- Posts: 9065
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 3 times
- Been thanked: 36 times
Re: Rear bearing puller r60/2
https://w6rec.com/the-2-wheel-bearings/
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
Re: Rear bearing puller r60/2
'63 r60/2
Scituate, MA
- schrader7032
- Posts: 9065
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 3 times
- Been thanked: 36 times
Re: Rear bearing puller r60/2
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
- jwonder
- Posts: 784
- Joined: Wed Nov 23, 2016 7:50 pm
- Location: Long Island, New York
- Has thanked: 3 times
- Been thanked: 8 times
- Contact:
Re: Rear bearing puller r60/2
For future reference this usually happens because you did not get the pocket of the bearing hot enough. If you look in the back of the block (where the flywheel lives) you will see a nice round bump and that is the rear pocket for the camshaft bearing. You need to heat that to 200 degrees F before you pull the cam out.
The Barrington Manual goes into how to get it out if it is left behind, but I am not home and do not have it in front of me.
If it was me I would get a small inside puller, could even be a small slide hammer that has inside jaws (I just looked up a slide hammer and puller set at Harbor Freight for $27). I would not spend much as once you have the rear pocket heated to 200 degrees it should come out fairly easily.
I hope this helps, but its not that bad of a situation. If you don’t have it already I strongly suggest buying the Barrington book. It is well worth the money in many ways!!
Good luck and please report back on how you fixed it so we have it for the archives!!!
Vice President, Vintage BMW Motorcycle Owners
2022 BMW Friend Of the Marque
Long Island, New York
Re: Rear bearing puller r60/2
'63 r60/2
Scituate, MA
Re: Rear bearing puller r60/2
Dave
-
- Posts: 29
- Joined: Wed Nov 16, 2016 11:55 pm
Re: Rear bearing puller r60/2
It pulls the rear camshaft bearing out easily.
Re: Rear bearing puller r60/2
'63 r60/2
Scituate, MA