By joining you will help ensure that we can continue to provide this service
JOIN HERE!
1969 R69S wiring diagram
-
- Posts: 288
- Joined: Fri Oct 27, 2006 3:00 am
- Has thanked: 18 times
- Been thanked: 4 times
1969 R69S wiring diagram
- schrader7032
- Posts: 9086
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 3 times
- Been thanked: 40 times
I'm not aware of any 1969
If you think there's power getting to the negative side of the light, hook the negative end of the meter up to the battery ground and use the positive lead on the meter to probe the wiring to see exactly where the 6v is and isn't.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
- wa1nca
- Posts: 1239
- Joined: Thu Sep 27, 2012 5:15 pm
- Location: Ashfield Ma
- Has thanked: 13 times
- Been thanked: 18 times
Tailight wiring
To verify the ground wire
With key off connect you ohm meter to the frame or negative on the battery
remove the 2 bulbs and find out which of the 3 wires is ground and make sure it is connected to the ground side of the tailight socket
Tommy
54 R51/3, 55 R50/Velorex 560 sidecar, 64 R27, 68 R69US, 75 R75/6
Ashfield, Ma
USA
-
- Posts: 288
- Joined: Fri Oct 27, 2006 3:00 am
- Has thanked: 18 times
- Been thanked: 4 times
Thanks for the tip. I am not
One more question, the left side switch(new) for high and low beam has different colors than the diagrams have. Not sure how to sort them out. The diagram shows yellow, yellow & black, black, green.
My new replacement switch, yellow ,yellow & white, white,green.
I appreciate your help and direction, I realize troubleshooting wiring on line is difficult. Thanks, Michael
- schrader7032
- Posts: 9086
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 3 times
- Been thanked: 40 times
I've looked at several
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
- wa1nca
- Posts: 1239
- Joined: Thu Sep 27, 2012 5:15 pm
- Location: Ashfield Ma
- Has thanked: 13 times
- Been thanked: 18 times
electrical issues
One more question, the left side switch(new) for high and low beam has different colors than the diagrams have. Not sure how to sort them out. The diagram shows yellow, yellow & black, black, green.
My new replacement switch, yellow ,yellow & white, white,green.
I appreciate your help and direction, I realize troubleshooting wiring on line is difficult. Thanks, Michael
Did this happen after you changed your wiring harness
or tried installing the new dimmer switch
switch
yellow same as yellow feed to low beam 56b connector at headlight receptacle
yellow/white same as yellow/black power for headlight 56 on switch board
white same as black feed to high beam 56a connector at headlight receptacle
green same as green
note:
Green Wire
original switch from 15/54 on switch board power to flash high beam 56a when switch is pushed in
later version switch from HO on switch board to sound horn when switch is pushed in
It ok to call me
leave message best time to call back if I dont pickup
413 628 3958
Tommy
54 R51/3, 55 R50/Velorex 560 sidecar, 64 R27, 68 R69US, 75 R75/6
Ashfield, Ma
USA
- wa1nca
- Posts: 1239
- Joined: Thu Sep 27, 2012 5:15 pm
- Location: Ashfield Ma
- Has thanked: 13 times
- Been thanked: 18 times
brake light/switch
Tommy
54 R51/3, 55 R50/Velorex 560 sidecar, 64 R27, 68 R69US, 75 R75/6
Ashfield, Ma
USA
-
- Posts: 288
- Joined: Fri Oct 27, 2006 3:00 am
- Has thanked: 18 times
- Been thanked: 4 times