By joining you will help ensure that we can continue to provide this service
JOIN HERE!
oil sensor leaking
- schrader7032
- Posts: 9057
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 3 times
- Been thanked: 36 times
oil sensor leaking
The oil filter's on the right side...the oil level (really the pressure) sensor is on the left side. I can't see that the new leak at the sensor has anything to do with the oil change. I think it's "just bad timing". These sensors go bad after a while and leak just like you're talking about...right through the middle. Before you consider changing it, clean everything real well, and dust the area with baby powder or talcum. Then go for a ride or two. Monitor where the oil drip starts from. Just to be sure it is indeed the sensor.
Changing it is no big deal...lean the bike over the to the right side, take out the old one, insert the new one. Don't over tighten the new sensor...that can break the center portion and you're back where you started.
Parts source? You're in Sunnyvale, CA, right? I'd say look up Ted Porter at the Beemershop - http://www.beemershop.com. He knows Airheads inside and out and can give you words of advice.
I've been using about 3-4 books for my /7. I have a very old Clymer that serves now as my on-bike manual for trips. I tend to look a lot at my most recent Haynes...lots of pictures. A believe Clymer has newer versions. Might check with Ted and see what he recommends. It's probably a good idea to get at least a couple so you can bounce them off each other and make sure things make sense. All of the books have some errors in places...even BMWs shop manuals. So, it's good to check and double check on torques, specs, etc.
Kurt in S.A.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
thanks Kurt
oil sensor leaking
I bought 1974 R60/6 few weeks ago. I changed the oil and filters, put maybe 50 miles after with no problem. Now I noticed there is oil dripping from oil lever sensor, the leak is between the aluminium nut and the plastic insert. Does it have to do anything with the oil change? Or the level sensor just went bad? The oil level is where supposed be, the bike is running like before. I changed the oil for first time, followed the manual, didn’t see any problems. Just want to make sure I did it correctly. If the problem is the sensor, is there good source for parts?
What’s the best book about maintaining R60/6?
Thanks Michal