By joining you will help ensure that we can continue to provide this service
JOIN HERE!
R51/2 - rocket arm washer
R51/2 - rocket arm washer
i did the adjustment of valves clearance according to owner manual
I noticed that also the axial clearance of the rocket arms vary a lot. Especially one (enclosed the picture)
I see there are available different washer tickness from 1.7 to 2.1 mm to compensate. Is there anybobody which knows how much shall be the axial clearance of exaust and intake rocket arm?
thx for info
Re: R51/2 - rocket arm washer
-
- Posts: 18
- Joined: Sun Jul 16, 2023 2:34 pm
- Has thanked: 1 time
Re: R51/2 - rocket arm washer
Re: R51/2 - rocket arm washer
yes, I was also thinking to clamp the two supporting brackets to reduce the clearance, but then I look at the exploded view.
If i m not wrong, there are two machined slots on the bearing bolt which engage the two stud bolts. Is there enough clearance between these slots and the stud bolts to make the adjustment?
I can try anyhow if works