Hello,
I own a 1963 R50/2 with rebuilt Bing carbs 131&132. Carbs are setup to the Bing Carb Spec Sheet. Main 135, Needle 1308, Idle Jet 35, Jet Needle 255, Clip Position 3 from top, Idle Mix Setting 2 out (start point). My question is what is a good start point for the slide adjusters?
Thanks, Gary
If you like our site, please consider joining our club!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!
R50/2 Bing Carb Slide Setting
-
schrader7032
- Posts: 9058
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 3 times
- Been thanked: 36 times
Re: R50/2 Bing Carb Slide Setting
Welcome to the forum! You provided the specs for the carb from Bing...in my mind, those are good starting points. What else do you mean for starting points for the slide?
Kurt
Kurt
Kurt in S.A.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
-
wa1nca
- Posts: 1234
- Joined: Thu Sep 27, 2012 5:15 pm
- Location: Ashfield Ma
- Has thanked: 13 times
- Been thanked: 18 times
Re: R50/2 Bing Carb Slide Setting
Starting points for the slide?
Do you mean the starting point for the slid at idle
If so, adjust the idle screw up so the slid raises just a little on both sides and then do a final adjustment after the bike is running and warmed up
Do you mean the starting point for the slid at idle
If so, adjust the idle screw up so the slid raises just a little on both sides and then do a final adjustment after the bike is running and warmed up
Tommy Byrnes
54 R51/3, 55 R50/Velorex 560 sidecar, 64 R27, 68 R69US, 75 R75/6
Ashfield, Ma
USA
54 R51/3, 55 R50/Velorex 560 sidecar, 64 R27, 68 R69US, 75 R75/6
Ashfield, Ma
USA