Hone cylinders

Darryl.Richman · Post by **Darryl.Richman** » Tue Dec 15, 2009 5:55 pm

Texas is a pretty big place. You could go a little further and send them to Bore Tech in Batavia, OH: http://www.bore-tech.com/

schrader7032 · Post by **schrader7032** » Tue Dec 15, 2009 6:23 pm

Boring is a specialized task. Darryl provided one source. Ted Porter in California does this as does Tom Cutter in Pennsylvania.

General service could be had at:

Boxers by Bruce - Arlington, I think
Perry's Motorcycles and Sidecars - Ft. Worth

There are some dealers around which should be able to handle this. DFW BMW for Dallas/Ft Worth and Alamo BMW in San Antonio.

A few smaller shops, I'm sure...

Kurt in S.A.

ebeeby · Post by **ebeeby** » Wed Dec 16, 2009 4:40 pm

If you are near Dallas I can help you measure for roundness, ball hone and install rings. If you need to bire the cylinders I can recommend Ted Porter though turn around times are about 3 months.

Eric

mrw45 · Post by **mrw45** » Wed Dec 16, 2009 5:19 pm

Thanks for the advise guys. Talked to Bruce up in Arlington. Really nice guy.

Eric - I'll send you an email to discuss.

Thanks again everyone!

VBMWMO · Post by **VBMWMO** » Mon Feb 15, 2010 2:53 pm

Can anyone recommend anyone in Texas to hone/bore my r75/5 cylinders and recondition/replace piston rings?

Thanks