By joining you will help ensure that we can continue to provide this service
JOIN HERE!
Final touches on rebuilding of R50/2
- Darryl.Richman
- Posts: 2138
- Joined: Fri Oct 27, 2006 3:00 am
- Has thanked: 1 time
- Been thanked: 9 times
Final touches on rebuilding of R50/2
I am contemplating a passenger saddle for the rear fender and am wondering the proper way to mount without messing the paint up. Any clever washers, pads or bolting techniques so that if my wife decides not to take my offer to ride I can take it off and not cry at the not so perfect fender? Also my kill wire is not working and short of taking the circuit board off again is there a way to wire that little wire to 2 that feeds the kill switch? One more thing, is there a better gas cap gasket available than that damn cork? Cracks in no time!
I always rub silicone grease
Joel
- schrader7032
- Posts: 9057
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 3 times
- Been thanked: 36 times
A bit of a repeat on this
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.