Page 2 of 2
Re: GEN Light stays on
Posted: Mon Sep 19, 2022 7:18 pm
by CraigMac79
Thank you, i think I have that documentation. The battery is less that two years old.
Re: GEN Light stays on
Posted: Mon Sep 19, 2022 7:24 pm
by schrader7032
Well, do as ST says. Measure the voltage at the battery terminals with the engine at an elevated RPM. Most likely it will not rise much above 12.5v or so. Also measure the voltage at the battery terminals while you start the bike. The voltage during starting should not go below 10v.
Re: GEN Light stays on
Posted: Mon Sep 19, 2022 10:07 pm
by srankin
Ah, again, I am skimming the data and not properly reading things. You installed an Enduralast ED4 for lithium batteries?
Sorry in this case, I would not know how to bypass the voltage regulator as can be done on the stock style systems.
The voltage regulator and diode board are incorporated into one unit on the ED4Li system from what I can see in the document. Without knowing just what wires to bypass, there could be a risk of popping a diode in the rectifier if done incorrectly.
As there is rewiring involving the factory wiring adding wiring, or re routing wiring to fit, those connections would be the first place I would check. I am sure it will be a simple issue. Sorry I can't help more Good luck, St.