If you like our site, please consider joining our club!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!

How to fit the Krauser cast carrier rack

Post Reply
User avatar
malmac
Posts: 796
Joined: Sun Jun 29, 2014 2:10 am
Location: Toowoomba, Australia.
Has thanked: 1 time

Re: How to fit the Krauser cast carrier rack

Post by malmac »

Well I borrowed a set of panniers, to check on the fit.
That seems fine.
The carrier is, not quite finished, but close.
I will give it a run as is, before I get it painted.

Anyone who said this job would be quick and easy, is obviously a lot cleverer than me.
Note bent indicator stork on right side.

Cheers

Mal
carrier06.jpg
mal - R69s
Toowoomba- Australia
Top
User avatar
schrader7032
Posts: 9040
Joined: Fri Oct 27, 2006 3:00 am
Location: San Antonio, TX
Has thanked: 2 times
Been thanked: 34 times

Re: How to fit the Krauser cast carrier rack

Post by schrader7032 »

Is it bent or is it just tilted? Maybe loosen a few bolts in the center, realign, and tighten??
Kurt in S.A.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
Top
User avatar
malmac
Posts: 796
Joined: Sun Jun 29, 2014 2:10 am
Location: Toowoomba, Australia.
Has thanked: 1 time

Re: How to fit the Krauser cast carrier rack

Post by malmac »

schrader7032 wrote: ↑
Sat Jan 14, 2023 8:19 am
 Is it bent or is it just tilted? Maybe loosen a few bolts in the center, realign, and tighten??
No the stork is bent down slightly.

Never mind it can be fixed or replaced, when I get around to it.

Mal
mal - R69s
Toowoomba- Australia
Top
Post Reply

Return to “Classic (1970-25 years ago) Motorcycles”