If you like our site, please consider joining our club!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!

Making Domed Washers

Post Reply
User avatar
malmac
Posts: 637
Joined: Sun Jun 29, 2014 2:10 am
Location: Toowoomba, Australia.

Making Domed Washers

Post by malmac »

I thought some of you might be interested in how I made some domed washers.

This is how you might make new ones for at the top of the rear shock absorbers.
These ones were not made for there but the process would be the same.
Metal thickness is 1.5mm stainless steel.

I used my hydraulic press at 2000kgs to press them, but it could have been done with a lump hammer,
they didn't need that much pressure.

Mal
MAL_1586.jpg
mal - R69s
Toowoomba- Australia

Post Reply