If you like our site, please consider joining our club!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!

'63 r60 losing power after warmed up

User avatar
Ziggy
Posts: 77
Joined: Thu Oct 29, 2020 10:34 am
Location: Massachusetts

'63 r60 losing power after warmed up

Post by Ziggy »

New to forum. Power loss consistent after bike warms up - 12 to 15 miles of riding. Recently cleaned magneto, installed new coil, points, condenser (from Vech, who has been great.) Properly set gaps, timed ignition. Also changed rings on one cylinder with low compression. New plugs, good spark. Starts on one kick cold. Bike will re-start if left to cool some, but exhibits pretty immediate power loss when up to temperature. Bad coil? Condenser? Both? Any way to test either?
JF Rogers
'63 r60/2
Scituate, MA

User avatar
jwonder
Posts: 784
Joined: Wed Nov 23, 2016 7:50 pm
Location: Long Island, New York
Has thanked: 3 times
Been thanked: 7 times
Contact:

Re: '63 r60 losing power after warmed up

Post by jwonder »

I would check the compression cold and hot. I would guess that you have low compression when the engine is hot.
James Wonder
Vice President, Vintage BMW Motorcycle Owners
2022 BMW Friend Of the Marque
Long Island, New York

User avatar
Ziggy
Posts: 77
Joined: Thu Oct 29, 2020 10:34 am
Location: Massachusetts

Re: '63 r60 losing power after warmed up

Post by Ziggy »

Did compression when bike was warmed up, first dry - showed low compression on one side. Did again wet, which brought up compression, so replaced the rings on that side. If compression is now significantly different between sides, can that result in power loss?
JF Rogers
'63 r60/2
Scituate, MA

User avatar
schrader7032
Posts: 9016
Joined: Fri Oct 27, 2006 3:00 am
Location: San Antonio, TX
Has thanked: 2 times
Been thanked: 29 times

Re: '63 r60 losing power after warmed up

Post by schrader7032 »

What are your compression numbers? Have you considered a leak down test?
Kurt in S.A.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.

User avatar
Ziggy
Posts: 77
Joined: Thu Oct 29, 2020 10:34 am
Location: Massachusetts

Re: '63 r60 losing power after warmed up

Post by Ziggy »

Dry they were 125 and barely 100. Have not re-tested with new rings. And, have never done a leakdown, but maybe should?
JF Rogers
'63 r60/2
Scituate, MA

User avatar
schrader7032
Posts: 9016
Joined: Fri Oct 27, 2006 3:00 am
Location: San Antonio, TX
Has thanked: 2 times
Been thanked: 29 times

Re: '63 r60 losing power after warmed up

Post by schrader7032 »

Did you ensure that the carb slides were completely pulled up when doing the check? I'm thinking that 125 psi compression is not that horrible...better if both sides are the same. If your compression numbers are something you can't live with, then a leak down test will tell you were the air is escaping to. That way you know if the problem is the rings or if it's the valves.
Kurt in S.A.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.

User avatar
Twocams
Posts: 781
Joined: Sun Mar 16, 2014 8:42 pm

Re: '63 r60 losing power after warmed up

Post by Twocams »

Did you check both Carbs to make sure they both had enough gas in them after running. I like to hook up a timing light to the plug wires. Point at my face and pull the trigger for both sides, see if there is any difference in the firing of each. No it wont blind you if you hold at arms length. :shock:
Twocams
92 R100RT/69 R69S
2004 Aprilia Atlantic 500cc single cylinder Scooter
83 Honda V65 Magna, fastest production bike in1983
2015 Can Am Spider SE6 1,688 miles
2018 Moto Guzzi V711 Special

User avatar
Ziggy
Posts: 77
Joined: Thu Oct 29, 2020 10:34 am
Location: Massachusetts

Re: '63 r60 losing power after warmed up

Post by Ziggy »

Did not check carb slide position. Will retest compression, and check firing with timing light. Still thinking about new coil/condenser if all else checks out.
JF Rogers
'63 r60/2
Scituate, MA

User avatar
Ziggy
Posts: 77
Joined: Thu Oct 29, 2020 10:34 am
Location: Massachusetts

Re: '63 r60 losing power after warmed up

Post by Ziggy »

Retested compression while hot with slides open. Numbers topped out at 120, even on the new ring side. Went for another ride after above mentioned compression (2 kicks to start), lost power at top of 2nd, into 3rd. Turned around and went home.
JF Rogers
'63 r60/2
Scituate, MA

User avatar
jwonder
Posts: 784
Joined: Wed Nov 23, 2016 7:50 pm
Location: Long Island, New York
Has thanked: 3 times
Been thanked: 7 times
Contact:

Re: '63 r60 losing power after warmed up

Post by jwonder »

Do you have fuel filters in the fuel lines? If so get rid of them and retest.

Could also be dirty filter in the petcock. Anything slowing fuel flow.
James Wonder
Vice President, Vintage BMW Motorcycle Owners
2022 BMW Friend Of the Marque
Long Island, New York

Post Reply