The secured nut is LH, btw.
What do you think?
- bending tab.jpg (271.6 KiB) Viewed 890 times
Engine Nr. 529466
The back half of the tab needs to go in the flat of the pump gear (You are about 180 degrees off) and the top is correct as you have it.
Think about it this way: If the nut tries to unscrew the top half is locked in the FLAT of the nut and the back half would be locked on the FLAT of the gear. There is no way for the nut to rotate then.
The way you have it now there is nothing to stop the nut from rotating, the tab is simply acting like a washer, not a locking device.
1967 R69S, 1966 R50/2, 1965 R27, 1963 R27, 1952 R51/3 and 2018 R1200GS
The tab in your picture should be bent down into one of the holes in the oil pump gear as shown buy the large arrow
then bent up behind the nut in 2 places as shown
- Inkedbending tab_LI.jpg (56.71 KiB) Viewed 856 times
54 R51/3 55 R50 64 R27 68 R69US