If you like our site, please consider joining our club!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!

oil in the exhaust

Post Reply
rmichel13
Posts: 27
Joined: Thu Jan 26, 2017 10:25 am

oil in the exhaust

Post by rmichel13 »

I am working on a 1974 r/60/5. I had the heads Honed and the valves reset and installed new rings. After reassembling the bike the left cylinder blows out a lot of smoke. I dissembled it and rechecked the rings and cylinder. I found 2 things 1: there was some oil between the piston and the head. and 2:that I installed the oil ring in backwards. After reinstalling the cylinder I still get smoke from the tailpipe and after turning off the ignition some oil leaks from the exhaust connection. Any Ideas?
Bob Michel

rmichel13
Posts: 27
Joined: Thu Jan 26, 2017 10:25 am

Spacer Question

Post by rmichel13 »

on a r60/2 can anyone tell me the thickness of the crank shaft spacer part # 110210016226. This goes on the rear of the crank between the rear bearing and the rear slinger.

Thanks
Bob Michel

User avatar
schrader7032
Posts: 9016
Joined: Fri Oct 27, 2006 3:00 am
Location: San Antonio, TX
Has thanked: 2 times
Been thanked: 29 times

I'm a little confused. Is it

Post by schrader7032 »

I'm a little confused. Is it a 1974 model or an R60/5? I see in previous posts, you mention an R60/6. Also, I can't find that part number...too many digits.
Kurt in S.A.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.

rmichel13
Posts: 27
Joined: Thu Jan 26, 2017 10:25 am

Spacer

Post by rmichel13 »

Thanks for your response. I have finished the r60/5 It is my nephews bike. I am now rebuilding r60 /2 motor I have had for years. Sorry about the part # I re-looked it up. The proper # is 11 210016266
Bob Michel

User avatar
schrader7032
Posts: 9016
Joined: Fri Oct 27, 2006 3:00 am
Location: San Antonio, TX
Has thanked: 2 times
Been thanked: 29 times

I've never been this deep in

Post by schrader7032 »

I've never been this deep in one of these engines, but this page in RealOEM mentions 2.0mm:

https://www.realoem.com/bmw/enUS/showpa ... 1210016266


Kurt in S.A.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.

rmichel13
Posts: 27
Joined: Thu Jan 26, 2017 10:25 am

spacer

Post by rmichel13 »

Thanks that's what I needed to know. I had to tear the motor completely down. The rear bearing went out caused the motor to knock. I took it apart about a year ago and am just getting around to putting it back together. I appreciate the help.
Bob Michel

Post Reply