By joining you will help ensure that we can continue to provide this service
JOIN HERE!
How to fit the Krauser cast carrier rack
- malmac
- Posts: 796
- Joined: Sun Jun 29, 2014 2:10 am
- Location: Toowoomba, Australia.
- Has thanked: 1 time
Re: How to fit the Krauser cast carrier rack
That seems fine.
The carrier is, not quite finished, but close.
I will give it a run as is, before I get it painted.
Anyone who said this job would be quick and easy, is obviously a lot cleverer than me.
Note bent indicator stork on right side.
Cheers
Mal
Toowoomba- Australia
- schrader7032
- Posts: 9038
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 2 times
- Been thanked: 34 times
Re: How to fit the Krauser cast carrier rack
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
- malmac
- Posts: 796
- Joined: Sun Jun 29, 2014 2:10 am
- Location: Toowoomba, Australia.
- Has thanked: 1 time
Re: How to fit the Krauser cast carrier rack
No the stork is bent down slightly.schrader7032 wrote: ↑Sat Jan 14, 2023 8:19 amIs it bent or is it just tilted? Maybe loosen a few bolts in the center, realign, and tighten??
Never mind it can be fixed or replaced, when I get around to it.
Mal
Toowoomba- Australia