By joining you will help ensure that we can continue to provide this service
JOIN HERE!
Question - swing arm out, what should I do?
- srankin
- Posts: 1078
- Joined: Fri Jul 14, 2017 8:45 pm
- Location: Spencerport, NY USA
- Been thanked: 17 times
Re: Question - swing arm out, what should I do?
Re: Question - swing arm out, what should I do?
Thanks again guys.
--My wife
- srankin
- Posts: 1078
- Joined: Fri Jul 14, 2017 8:45 pm
- Location: Spencerport, NY USA
- Been thanked: 17 times
Re: Question - swing arm out, what should I do?
https://www.cycleworks.net/index.php?ma ... ucts_id=57
I have the BMW tool, here https://www.boxer2valve.com/kukko-beari ... -21-5.html. It is part of a set needing this part as well.https://www.boxer2valve.com/kukko-pulle ... -22-2.html
They are expensive for a one or two shot use. The Cycle works tool, I have no experience with but it may work fine.
The problem is, the race is fit into the swing arm without much of a way to get "under" it to lift it out of the swing arm. Same goes for steering head bearings as well.
If you change the bearings, you must change the races, without a tool, it will be hard to get the race out unless you cut them out. St.
- Flx48
- Posts: 262
- Joined: Sun Oct 25, 2020 3:11 pm
- Location: NW CT
- Has thanked: 2 times
- Been thanked: 6 times
Re: Question - swing arm out, what should I do?
Best-
George
Re: Question - swing arm out, what should I do?
--My wife
- srankin
- Posts: 1078
- Joined: Fri Jul 14, 2017 8:45 pm
- Location: Spencerport, NY USA
- Been thanked: 17 times
Re: Question - swing arm out, what should I do?
Nah, just kidding, I like proper tools to do the job so I have the set. it has made things easier in a lot of cases working on my bikes or my friend's bikes.
Have fun and good luck. St.