By joining you will help ensure that we can continue to provide this service
JOIN HERE!
S fairing installation
Re: S fairing installation
Fit the fairing and put the eccentric on from the outside. Turn it to alter/match the height to the top mounts. Then push the flat rubber washer onto the eccentric where it protrudes through the fairing.
The "U" washer fits on the inside and the steel 3mm washer on the outside with the indicator body pushed hard up against it.
If you cannot get the indicator to fit on the holding bracket,152, you have the wrong/short bracket.
Oem was 31421233943 superseded by 31422301607?
Hope this helps.
Re: S fairing installation
If that's what you have, do yourself a favour and bin it!
Be aware that the exploded fairing parts drawing used on most sites is NOT in the correct assembly order!
- schrader7032
- Posts: 9040
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 2 times
- Been thanked: 34 times
Re: S fairing installation
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
- malmac
- Posts: 796
- Joined: Sun Jun 29, 2014 2:10 am
- Location: Toowoomba, Australia.
- Has thanked: 1 time
Re: S fairing installation
Also I hope I have the respective materials correct. Rubber bits, metal bits.
I have tweaked the image to make the assembly order that I think is correct.
Please correct me if I have it wrong.
Thanks again for everyones help.
Mal
Toowoomba- Australia
Re: S fairing installation
Good diagram, I'm sure it will help folk in the future
- malmac
- Posts: 796
- Joined: Sun Jun 29, 2014 2:10 am
- Location: Toowoomba, Australia.
- Has thanked: 1 time
Re: S fairing installation
Here is what I have assembled so far.
I made item 1 and 2, used a suitable "O" ring for item 3 and modified a purchased grommet for item 4.
I know there is another spacer to make but I will wait till the fairing is on the bike and I will make the spacer to suit the gap.
Also the inside diameter of item 4 is over size, so I will make a suitable sleeve to fill the gap.
Onward and upward.
Mal
Toowoomba- Australia
-
- Posts: 6
- Joined: Thu Jan 26, 2023 3:42 am
Re: S fairing installation
Mounting looks OK.
-
- Posts: 81
- Joined: Sun Oct 13, 2019 2:47 pm