If you like our site, please consider joining our club!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!

Fitting new breather plate to 20 degree gears

Post Reply
User avatar
malmac
Posts: 796
Joined: Sun Jun 29, 2014 2:10 am
Location: Toowoomba, Australia.
Has thanked: 1 time

Fitting new breather plate to 20 degree gears

Post by malmac »

Doug and Mal are doing some work on Doug's R51/3.

The engine had the old single pin breather plate.
Given their reputation for failure, seemed that a new style breather plate would be the ticket.
Following are some photos taken while Doug and Mal modified the old style 20 degree cam gear to accomodate the new cast in pins breather plate.

Pic 1 - gear with new breather plate
202.jpg
Pic 2 - Interference fit plugs used to fill old over sized holes. .03mm interference fit. The plugs have a lip which prevents them migrating out the back side of the gear and the washer in the front prevent escape forwards. Gear was heated to 250F and the plugs were still a press fit. They probably won't be moving anytime soon.
Cam gear 15.jpg
Pic 3 - The old gear with the 15mm oversized holes plugged
Cam gear 21.jpg
Pic 4 - Using an old cast in pins breather plate we were able to drill pilot holes. vertical pin links the location of the 5mm pin hole.
Cam gear 23.jpg
Pic 5 - The fixtures we turned up so we could hold the gear at various stages and drill the right sized holes in the right place. You can note the new smaller 12.25mm holes.
Cam gear 28.jpg
mal - R69s
Toowoomba- Australia

Post Reply