If you like our site, please consider joining our club!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!

Correct foot peg for center stand R69S?

Post Reply
pkrpkr
Posts: 40
Joined: Sat Jun 25, 2016 10:58 am

Correct foot peg for center stand R69S?

Post by pkrpkr »

Thinking of renewing the center stand of my R69S but it seems the foot peg on the currently available stands are sort of flattened while the peg on mine has a circular cross section.
Any opinions about what is correct? It's possible that mine was once repaired and is wrong but then I saw a stand on Duane's site which is same as mine.
Thanks in advance,
Peter
This is from Duan'e site:
centerstand-tubes.jpg

xackley
Posts: 111
Joined: Sat Oct 14, 2006 4:09 pm
Been thanked: 2 times

Re: Correct foot peg for center stand R69S?

Post by xackley »

I took a look at mine.
Slightly flattened, about 5" long on a 1958.
Perhaps they changed over the years to round.

Don
1958 R69, 1972 R75/5, 1980 XS650, 1982 GL1100, 2003 guzzi ev, 2017 guzzi V7!!!
All on the road, going no where in particular in the Finger Lakes of New York

MikeL46
Posts: 151
Joined: Fri Jan 01, 2016 1:58 pm

Re: Correct foot peg for center stand R69S?

Post by MikeL46 »

I've had several R69S and /2 bikes. Never seen a round foot peg on the center stand.

Mike
67 R50/2 w/R100 engine/trans and Ural Sidecar
69 R60/2 76 R90S 78 R100RS
70 Triumph w/Spirit Eagle Sidecar

User avatar
niall4473
Posts: 174
Joined: Mon Apr 09, 2007 2:54 pm
Location: U.K.
Been thanked: 9 times

Re: Correct foot peg for center stand R69S?

Post by niall4473 »

For what it is worth, that is most definitely not an R69S stand in the photograph, it is a late R51/3, R67/2 or R68.
Oil is always cheaper than metal

User avatar
wa1nca
Posts: 1213
Joined: Thu Sep 27, 2012 5:15 pm
Location: Ashfield Ma
Has thanked: 6 times
Been thanked: 12 times

Re: Correct foot peg for center stand R69S?

Post by wa1nca »

The center stand for the plunger models and r50 r69s models are not interchangeable but the rounded foot peg is similar to the plunger models
Tommy
Tommy Byrnes
54 R51/3, 55 R50/Velorex 560 sidecar, 64 R27, 68 R69US, 75 R75/6
Ashfield, Ma
USA

pkrpkr
Posts: 40
Joined: Sat Jun 25, 2016 10:58 am

Re: Correct foot peg for center stand R69S?

Post by pkrpkr »

Thanks everyone and have a good 2022!

Post Reply