Making Domed Washers
Posted: Sun Dec 19, 2021 6:10 pm
I thought some of you might be interested in how I made some domed washers.
This is how you might make new ones for at the top of the rear shock absorbers.
These ones were not made for there but the process would be the same.
Metal thickness is 1.5mm stainless steel.
I used my hydraulic press at 2000kgs to press them, but it could have been done with a lump hammer,
they didn't need that much pressure.
Mal
This is how you might make new ones for at the top of the rear shock absorbers.
These ones were not made for there but the process would be the same.
Metal thickness is 1.5mm stainless steel.
I used my hydraulic press at 2000kgs to press them, but it could have been done with a lump hammer,
they didn't need that much pressure.
Mal