By joining you will help ensure that we can continue to provide this service
JOIN HERE!
Making Domed Washers
- malmac
- Posts: 796
- Joined: Sun Jun 29, 2014 2:10 am
- Location: Toowoomba, Australia.
- Has thanked: 1 time
Making Domed Washers
This is how you might make new ones for at the top of the rear shock absorbers.
These ones were not made for there but the process would be the same.
Metal thickness is 1.5mm stainless steel.
I used my hydraulic press at 2000kgs to press them, but it could have been done with a lump hammer,
they didn't need that much pressure.
Mal
Toowoomba- Australia