If you like our site, please consider joining our club!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!

Con-Rod issue

Post Reply
1967 R502
Posts: 143
Joined: Thu Jan 25, 2018 11:47 am

Con-Rod issue

Post by 1967 R502 »

Hi-

I’m dealing with the results of a seizure.

The left con-rod on a /2 was starved for oil. The piston, pin and bushing were totaled. In order to remove the latter I had to use a torch on the small end.

In retrospect , I feel that the torch was maybe a mistake. On a modern rod for sure, it would be a no-no as they carry a high Rockwell hardness, but these old rods are a VERY mild steel.

Has anyone done this, and if so were there any consequences?

Subsequent question: I have not heard good things about new rods. Anyone have direct experience?

Post Reply