If you like our site, please consider joining our club!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!

1954 Female wheel hubs/Splines

flyingtpot
Posts: 71
Joined: Fri Oct 27, 2006 3:00 am
Been thanked: 6 times

coupler review

Post by flyingtpot »

The splined coupler should be separate from the drum section.When reviewing that factory hub in post #9, the cleco tooling from the half width hub seemed to be feasible to use. It was the fixturing for the obscured/hidden portion of the rivets that required a unique fixture to get 'inside' the cast aluminum webs'spokes. For the half width hubs, the fit of the replacement couplers were a precision fit to the drums.
Attachments
full_hub_coupler.jpg
full_hub_coupler.jpg (29.16 KiB) Viewed 725 times

Post Reply