Progress on R47 .

[speight1823]

Had to make new rockers for the R47 . The ones on the bike were worn out and from another model.
Remade rockers from Bohler K110 steel and hardened to 50 RW. Location is via octagonal hole in rocker boss and shaft with a .02 mm interference fit. A 8 mm ht bolt runs through the center . Bearings are standard sealed roller bearings.
I did not make rockers as standard as I don't think I can make a roller bearing and I don't like the lubrication.

Now ready for final assembly . Hopefully all goes well

Bill

[lauffer6996]

Nice!
scott

[Peter]

Excellent work Bill, very impressive.