Good evening. I would like someone to tell me how I can pull out the dynamo to change the timing chain. If you could send some photos or sketches will appreciate. The motorcycle is my one R26 1957.
Do need a special tool? Since I read and I could understand, this is done using the bolt is screwed into the shaft and keeps the whole system. Is this true and if so how can I handle it?
Thank you very much!
If you like our site, please consider joining our club!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!
By joining you will help ensure that we can continue to provide this service
JOIN HERE!
Please Help! R26 dynamo.
-
schrader7032
- Posts: 9056
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 3 times
- Been thanked: 36 times
This
This book:
http://www.snafu.org/restore/uandm_bmw_v1.pdf
describes how to remove the rotor on a /2 generator. The /2 as far as I've come to know represents the twins cylinder bikes from '55 to '69. But your R26 is a '57, so I'm pretty sure that it contains the same components in terms of the generator.
http://www.snafu.org/restore/uandm_bmw_v1.pdf
describes how to remove the rotor on a /2 generator. The /2 as far as I've come to know represents the twins cylinder bikes from '55 to '69. But your R26 is a '57, so I'm pretty sure that it contains the same components in terms of the generator.
Kurt in S.A.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.