rear rubber engine mounts on R27
Posted: Tue May 08, 2007 7:17 am
Jeffrey -
Can't say that I've seen one of these up close, but I asked around on some other forums. Not sure if you're a member of the Yahoo singles forum...you might get some good advice over there.
What I heard was that, yes, it can be done without removing the engine. Someone specifically said you'd need a 22mm openend wrench that is 4mm thick. Also, depending on where you get the parts (Blue Moon?), you might ask them for advice on how to proceed.
Kurt in S.A.
Can't say that I've seen one of these up close, but I asked around on some other forums. Not sure if you're a member of the Yahoo singles forum...you might get some good advice over there.
What I heard was that, yes, it can be done without removing the engine. Someone specifically said you'd need a 22mm openend wrench that is 4mm thick. Also, depending on where you get the parts (Blue Moon?), you might ask them for advice on how to proceed.
Kurt in S.A.