By joining you will help ensure that we can continue to provide this service
JOIN HERE!
Dual Disc Conversion r90/6
Dual Disc Conversion r90/6
I measured the space between the outside face of the disc, and the top "arm" on the slider at the closet point. Left side is 1.3mm and the right is 2.25mm. To shim out the right side will take one or possibly two washers, or bmw part # 34111232417.
All advice would be appreciated.
thank you
- schrader7032
- Posts: 9050
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 3 times
- Been thanked: 34 times
Re: Dual Disc Conversion r90/6
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.
Re: Dual Disc Conversion r90/6
thank you, glad to be a member. Sliders are fine, and even with each other. My issue is with the horizontal spacing. Simply, the left disc is closer to the left fork slider than the right disc to the right slider.
- schrader7032
- Posts: 9050
- Joined: Fri Oct 27, 2006 3:00 am
- Location: San Antonio, TX
- Has thanked: 3 times
- Been thanked: 34 times
Re: Dual Disc Conversion r90/6
https://www.realoem.com/bmw/enUS/showpa ... Id=34_0607
According to RealOEM, those "washers" 34111232417 are only used up to 9/1974. Seems like you shouldn't use them at all.
'78 R100/7 '69 R69S '52 R25/2
Fast. Neat. Average. Friendly. Good. Good.