Page 5 of 5
enduro saddle bags brackets holders
Posted: Wed Jul 26, 2017 2:36 pm
by oldtimers.si
hi,
we finish enduro saddlebags brackets holders version 2
you can install upper holder inside fenders
its ready for BMW R50 - R69S
( only for OLD Enduro Saddle Bags ABS )
regards,mec
lights
Posted: Tue Aug 22, 2017 5:07 pm
by skychs
Did you ever add a dual bulb socket to your saddlebags for running and brake lights ?
If so want did you do
Tommy
I never did the dual filament swap for the Enduro bags. I simply ran the wires from the bag lights to the block for brake lights. Running lights are nice but I think extra brake lights are a better application. Maybe down the road.
chuck
lghts
Posted: Tue Aug 22, 2017 5:38 pm
by skychs
Here are a couple photos of the bag lights on and off with the running lights. Not a huge difference during the day but noticeable at night.
Nice.
Posted: Wed Aug 23, 2017 9:11 am
by stagewex
Nice.
Trim
Posted: Mon Aug 28, 2017 7:12 am
by skychs
While Im here ....
I'd like to replace the seal/trim on the lids. It looks like one side has been replaced but it's different from the other side. Any idea where I can get the lid trim?
nice skychs , perfect
send me
Posted: Mon Aug 28, 2017 4:27 pm
by oldtimers.si
nice skychs , perfect
send me booth pictures , i look in my shop
maybe i find
regards,Mec
Lids
Posted: Thu Mar 15, 2018 7:44 pm
by skychs
I installed round rubber grommets in the holes that secure the pins in the lid. It makes the lid a little harder to install but I’m counting on it to keep my lid from blowing off in the wind. So far so good.