Original Enduro Saddle bag restoration

User avatar
oldtimers.si
Posts: 122
Joined: Mon Aug 18, 2014 11:00 am

enduro saddle bags brackets holders

Post by oldtimers.si »

hi,
we finish enduro saddlebags brackets holders version 2
you can install upper holder inside fenders
its ready for BMW R50 - R69S
( only for OLD Enduro Saddle Bags ABS )

regards,mec
Attachments
holders_enduro__bags_large.jpg
holders_enduro__bags_large.jpg (774.75 KiB) Viewed 324 times

User avatar
skychs
Posts: 371
Joined: Fri Nov 25, 2016 2:12 pm
Location: Richmond VA

lights

Post by skychs »

Did you ever add a dual bulb socket to your saddlebags for running and brake lights ?
If so want did you do

Tommy

I never did the dual filament swap for the Enduro bags. I simply ran the wires from the bag lights to the block for brake lights. Running lights are nice but I think extra brake lights are a better application. Maybe down the road.
chuck

User avatar
skychs
Posts: 371
Joined: Fri Nov 25, 2016 2:12 pm
Location: Richmond VA

lghts

Post by skychs »

Here are a couple photos of the bag lights on and off with the running lights. Not a huge difference during the day but noticeable at night.

Attachments
img_7976.jpg
img_7976.jpg (1.41 MiB) Viewed 324 times
img_7977.jpg
img_7977.jpg (1.33 MiB) Viewed 324 times

User avatar
stagewex
Posts: 460
Joined: Sun Oct 26, 2014 8:18 am

Nice.

Post by stagewex »

Nice.
mike wex/stagewex
1969 BMW r60/2, US Model, 1995 BMW K75, 2006 Yamaha TW200, 2007 Ural Patrol, 1991 Honda XR250L

User avatar
skychs
Posts: 371
Joined: Fri Nov 25, 2016 2:12 pm
Location: Richmond VA

Trim

Post by skychs »

While Im here ....
I'd like to replace the seal/trim on the lids. It looks like one side has been replaced but it's different from the other side. Any idea where I can get the lid trim?

Attachments
img_6743.jpg
img_6743.jpg (1.84 MiB) Viewed 324 times

User avatar
oldtimers.si
Posts: 122
Joined: Mon Aug 18, 2014 11:00 am

nice skychs , perfect send me

Post by oldtimers.si »

nice skychs , perfect

send me booth pictures , i look in my shop
maybe i find

regards,Mec

User avatar
skychs
Posts: 371
Joined: Fri Nov 25, 2016 2:12 pm
Location: Richmond VA

Lids

Post by skychs »

I installed round rubber grommets in the holes that secure the pins in the lid. It makes the lid a little harder to install but I’m counting on it to keep my lid from blowing off in the wind. So far so good.

Post Reply