Number plate installation without drilling

charles.walmsley · Post by **charles.walmsley** » Thu Feb 04, 2016 10:00 am

My R68 has just been relicenced. However I can't bare the thought of drilling a few holes into the nice rear fender as the bike has been restored. Any ideas on how I can install the number plate onto the rear fender without using screws, bolts, or adhesive tapes or products?

schrader7032 · Post by **schrader7032** » Thu Feb 04, 2016 3:32 pm

Is the number plate magnetic? That's about the only way I can think if those other methods are ruled out.

charles.walmsley · Post by **charles.walmsley** » Fri Feb 05, 2016 2:38 am

Possibly.. I'll try and give that a go. I was thinking of making up a bracket to hug around the fender then bolt the plate to the bracket instead of drilling through the fender.