Vintage BMW Motorcycle Owners

Hi
I sure am going to miss the Waterjet cutter when I retire to my bit of land.
Back to the grinder and hacksaw
Richard

Hi
I finally found time to draw and make the Ex Nut spanner. But I cannot attach DXF or DWG files.
If anyone wants a copy then just PM me.
Thanks
Richard

Hi
Yes I see that I can buy one.
But with access to Laser cutters and a Waterjet I really should make one myself.
I will draw up a spanner and post the files on here.
Just got busy at work...end of financial year and all that.
Thanks
Richard

Hi
Would anyone have a DXF or any other format file for an exhaust nut spanner?
Thanks
Richard

Hi Thanks for all the info. I will assume that the bike is what it is and just fit it all back together. The fact that the parts I seem to have didn't match any parts list I could find was making me think that I had lost some parts or was mixing parts from the clutch and brakes up. It doesn't help t...

Hi My 1974 model seems to have a few differences from what I can see in all the parts diagrams. Master Cylinder has never had a brake pressure switch...never even threaded for it. No Brake Switch thread.JPG The cable adjuster at the master cylinder is weird. The adjuster at the master cylinder is un...

Hi
Thanks for confirming that.
Also yes I think that the extra wire probably are for the brake fluid level.
I dont have the brake system on bike right now so couldn't see where the wire might have gone.
Thanks
Richard

Starter Relay Pin numbers.JPG Hi In the attached pic....Pins 86 85 and 87 I can see but... Are the pins circled in blue called pin 30 Are the pins circled in green called D+ If I have that correct then do I have my wiring colors to pin numbers correct... D+ connect Blue from Engine Harness and Blue...

Hi
Got bored so knock this up. 316 Stainless so should be as good as new.
Thanks
Richard

5.97mm diameter. 26.50mm length. Let me know if you plan to spin one up as the ends have a radius and I can give you those measurements and photos if needed. I hope this helps, Scott Hi Thanks that the info I needed. I will whip one up in the next few weeks. The end radius shouldn't be an issue..I ...