No replies
lavrider
lavrider's picture
 Offline
western Connecticut
Joined: 10/21/2011
Posts: 8

In a previous message I described how the taper surfaces on the flywheel and crankshaft of my R68 are pretty buggered up. I will be sending the crank out for service and the specialist thought the taper surface might be repairable.

Rather than try to repair the flywheel too, I thought it might be more economical to replace it with a used one with good taper surface.

Thus, I'm looking for an R68 flywheel, just the front-most piece. I understand that R67/3 and R51/3 flywheels are viurtually identical with the exception of the timing mark locations. If I can locate one of these, I will remark to R68 timing.

Thanks!
Paul