1 reply [Last post]
zebian2
zebian2's picture
 Offline
Seattle
Joined: 09/20/2008
Posts: 20

Could someone please post a picture(s) of the turn signal switch that is being used ?
Also beside the turn signal,relay and the switch is there anything else is involved to complete the installation?
Do you drill the Handlebar to run the wires?
Much appreciated.
Z

Allan.Atherton
Allan.Atherton's picture
 Offline
VBMWMO #2709
Joined: 10/27/2006
Posts: 507
Re: Can Someone Post a picture of the Turn Signal Switch Ple

"zebian2" wrote:

Could someone please post a picture(s) of the turn signal switch that is being used ? Also beside the turn signal,relay and the switch is there anything else is involved to complete the installation? Do you drill the Handlebar to run the wires?

Here are some pictures:
http://www.flickr.com/photos/roundel/sets/388085/
For the parts needed, go to the site below, then to Site Map, How To, and How To Install Bar-end Turn Signal:
http://www.benchmarkworks.com/
I have a further detailed write up I can send if you email me, including tips on drilling and notching the bars and running the wires.

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.