Mon, 07/09/2018 - 15:04
#2
Offline
Hi
I believe mine is
Hi
I believe mine is original.
It was made by thick leather
with spring press on it against the metal seat.
This method used also on the singels R20,23,35...
But with smaller diameter.
I can't install here modern oil seal due to heavy corrosion in side the hausing.
Mon, 07/09/2018 - 17:30
#3
Offline
drive shaft seal
Hello
were I can order this parts ?
its for R11,1934.
my parts.
Mon, 10/22/2018 - 12:57
#4
Offline
Thank you Ian
I just made one
Thank you Ian
I just made one by my self from 2 mm neoprene rubber.
hope it will do the job.
Tue, 10/23/2018 - 08:12
#5
Offline
Not sure about this.
The
Not sure about this.
The kickstart flange of a R51-R51/3 may fit with a bit of modifications.
I think the bolt pattern is the same as a R12
Lee
Tue, 10/23/2018 - 08:49
#6
Offline
Hello,
Your 1934 R11 is just
Hello,
Your 1934 R11 is just about the same as a R12.
Got to RRC-Tuning, link below.
http://www.rrc-tuning.de/en/oxid-oxid-2/Tafel-24-25-Drivegear/
Review the parts he has for sale.
Lee
Is your outer seal case the same as mine in the photo attached? I don’t know for certain if this part is original on mine but it is machined to accept a modern readily available rubber/nitrile oil seal, it works ok as well.
Otherwise I don’t know of a supplier for this part. The felt used for the original type seals is available but I have found it really difficult to cut well enough.
Sorry for the poor photo, but I just smashed one of the garage lights!